Hi..new here so pls excuse any protocol errors..could someone help me out with either some detailed instruction re: replacing part of/entire 'A' panel. It's rusted through around the bottom of the post where the wing bolts onto a captured nut. It's not extensive , but it definitely needs fixing..do I cut the panel out and replace the lower section..do I weld a new panel on top..any advice would be most welcome..and actually ditto the sills..there is some rust through the sills below the front doors..again, not extensive but requires attention..in this case would one cut and replace..plate or weld new part on top.i can post some pics if it's possible to do so..
Many thanks
Simon