Oops, I misread, I was thinking the other way around. Sorry.

Bryan, I read it the same as you did and think John misread. I agree about what you said. Going up in pitch is easier than going down, because it involves filing off metal at the tip of the tongue, which is far less destructive that taking it off the root/middle.

I think What John Doucet said is that he would use a piano accordion reed of the proper note and load the reverse side tip to lower the note, no grinding required. Works pretty good. However, a complete set of bass reeds can be purchased from Hohner.

On a previous subject concerning wire for the valve arms. Motor windings are too soft and flexible. Copper Ground wire is much stiffer. I have also used 1/8" brass rods which work well but are much harder to adjust. Friends in Quebec use nickel plated copper wire but most do not flatten the ends or install screws as in the past. They square the end and cut a slot in the valve and press the square end into the slot. Most have also gotten away from the mylar tape on the valves.

Ah, yeah, and round and round I go.

Back to my original thought, it is possible and even practical to tune the bass reeds a step up. I wouldn't do it with small treble reeds. Anyone disagree, please call me on it, but I've done it with no problems. I don't like loading reed tips if I don't have to, it works, but I feel it slows down the reed.

"B Stock" from a dealer.?

Is it Chinese made ? If so return it.

Buy a used German made 114.

I just bought an early 50's 114 in C in all original condition includint a cloth (original) not leather bass strap. These were the earliest.

The early German made units have better reeds, better materials and better workmanship.

B stock with a few scratches.. perhaps, but with the wrong bass reeds.. no way.

That isn't B stock, it's a defective, improperly built box. Off it.

I think he means that the accordion is the black 114 Hohner made for awhile which I think was called a B model?

"B" stock becasue of scratches according to the OP


HA114B had a black bellows and slightly not so wet tuning.
I owned one... good box but nothing special. I rebuilt mine on day one, I bought it new for $400 US.

Ah yes, I read the post again and saw that

Thanks for all the feedback everyone. After making some calls to see what can be done, I called Hohner to check on some parts prices and when I told them about my situation they said I could send it to them and they would either change out the reeds or send me a new accordion at no cost since it's a defect. I probably should have just called Hohner first, heh.